emptying interference volume in combination

[ceru1012]

Good morning, everyone, I need advice.
as I can do to remove from the axieme the interference volume, if possible without affecting the file of the part and always if possible without using the function "scratch"+"extruded cutting". . .

Thank you so much to those who will help me! !

 

[marcof]

Good morning, everyone, I need advice.
as I can do to remove from the axieme the interference volume, if possible without affecting the file of the part and always if possible without using the function "scratch"+"extruded cutting". . .

Thank you so much to those who will help me! !

move the component that interferes, it seems logical to me not?

 

[ceru1012]

I need to use it with two double "t" profiles that need to fit at the end... and so I need to eliminate the interference volume between the two...
I don't know if I explained well...

 

[MassiVonWeizen]

but to do a part, to use the structural members and/or the short function extend that is made on purpose is not possible?

 

[eboss]

or create a solid and empty it?
if you place the file will surely be easier to give suggestions.