Nicola Fantini
Guest
hi to everyone, I have seen that there is not yet a sub forum dedicated explicitly to esprit, I use this software for a couple of months and I am really finding myself well. But I need to improve and have advice and exchanges of opinions with those who are more experienced on 3d milling with this kind of software. I hope that in this debate we will be able to break up.
I also insert a question,
realization of floors with mirror finish, what process to use? I used a finishing of flat areas and if not bad I think it can improve also I used with smaller cutters a roughing mold to make the finish always on the floor and also it did not come bad but not even well. if someone makes you feel I can also my files for a better understanding of my "problem".
Greetings to all.
I also insert a question,realization of floors with mirror finish, what process to use? I used a finishing of flat areas and if not bad I think it can improve also I used with smaller cutters a roughing mold to make the finish always on the floor and also it did not come bad but not even well. if someone makes you feel I can also my files for a better understanding of my "problem".
Greetings to all.