riccaricca90
Guest
Bye to all,
I am trying to achieve a structural analysis of a turbocharged car group.
after drawing the parts (compressor, turbine, tree, spacers...) and creating the axieme (in the assembly) by binding the bodies between them, I should proceed by cutting 1/4 together to make the simulation only on that 1/4 together (using the symmetry of the impellers and the problem in general, so as to decrease the calculation times).
My problem arises here (being a novello of abaqus).
Does anyone have any idea how to extrude/cut/remain the assembly? (without eliminating constraints and contact between surfaces)
Thank you!
I am trying to achieve a structural analysis of a turbocharged car group.
after drawing the parts (compressor, turbine, tree, spacers...) and creating the axieme (in the assembly) by binding the bodies between them, I should proceed by cutting 1/4 together to make the simulation only on that 1/4 together (using the symmetry of the impellers and the problem in general, so as to decrease the calculation times).
My problem arises here (being a novello of abaqus).
Does anyone have any idea how to extrude/cut/remain the assembly? (without eliminating constraints and contact between surfaces)
Thank you!