export file step

[marco-v94]

hello to all, at work we have various computers on which nx 11.0.2 is installed and on two of them when you go to export a file in step format the terminal window opens and after some writings that runs closes. the result is the generation of the log file without creating the step.
tomorrow I try to upload the .log file.
thanks in advance for the help and... no, we don't have a

 

[marco-v94]

below the attachment of the .log file

 

[biXel]

Bye.
Does this occur systematically or only on some models?
Is it export of a single set or part?

I faced a similar problem and it was caused by video drivers.
Now, I don't know if it's your case, but the symptom is the same, so I ask you:
what version of the drivers?

 

[marco-v94]

Bye.
Does this occur systematically or only on some models?
Is it export of a single set or part?

I faced a similar problem and it was caused by video drivers.
Now, I don't know if it's your case, but the symptom is the same, so I ask you:
what version of the drivers?

we solved the problem by updating the video card.

thanks for the help

 

[biXel]

as I suspected.
Good job

 

[Mandrake83]

Bye.
Does this occur systematically or only on some models?
Is it export of a single set or part?

I faced a similar problem and it was caused by video drivers.
Now, I don't know if it's your case, but the symptom is the same, so I ask you:
what version of the drivers?

What a horse!