export of single configuration in non-owner format

[tanticapelli]

Bye to all,

I hope I do not address a subject already dealt with. . .

I'm about to send orders to a lasertube supplier.

to do this I would like to send an export 3d (the format is still to be agreed) of a part that contains many configurations of which only some will be of interest to the order.

I wondered if when you make a "Save with name" with format other than that standard solidworks export only the active configuration at that time or export the whole tree.

I'm worried that the supplier doesn't mess up (and neither do I).

thank you always

so many hairs

 

[MassiVonWeizen]

export only the active configuration.
just do some tests by saving and reimporting the file to notice it