export project

[katif]

Hello everyone

I use I create 2 and I would need to export a complete project (parts, aids and designs) to be able to pass them.
documents are spread over many folders in the filesystem, quinidi I would need an automated tool (type pack and go of solidworks).

I tried to open the assieme father and save copy, it works, but renames all the files with the suffix "_" and this for me is a problem.
I tried to save a backup, but not copy the designs.

Is there a solution?

Thank you.
Hi.

 

[luca1669]

Hi.
I had done a little program that worked with wildfire 4 to make backup of the boards as well. it was necessary that pro/e (now I create) had the possibility to open all the tables without having to look in the folders; basically it was enough to type the name of the table and he searched in all the paths indicated in the configuration of the program (searchpro_file). If you're in this condition as soon as I get home I'll send it to you then try it if it works. Consider that it will put us a bit because it will open the files one by one and will make it back up.

 

[katif]

Unfortunately I have files scattered on multiple folders.

 

[StefanoAntonio]

Hello everyone

I use I create 2 and I would need to export a complete project (parts, aids and designs) to be able to pass them.
documents are spread over many folders in the filesystem, quinidi I would need an automated tool (type pack and go of solidworks).

I tried to open the assieme father and save copy, it works, but renames all the files with the suffix "_" and this for me is a problem.
I tried to save a backup, but not copy the designs.

Is there a solution?

Thank you.
Hi.

I usually proceed like this:
I open all the drawings that interest me and then back up.in this way the drawing drags everything behind it

 

[katif]

but does not copy the drawings of the other components. . .
I would have too many drawings to open, so it would be too big a job.
it would serve something automated that leaves alone from the first level. . .