extrude text

[LordRaiden]

Hey, guys.
I have been registered at the forum since time immemore but I have never asked questions since you are very good and browsing the forum I always find answer to my doubts.
I have unfortunately not found this: how can I extrude a text? Or a pocket? I also tried to recalculate the text but it is not possible since it does not take snaps.

use thinkdesign for a few months and are not really practical of the program so if you have the solution please be precise:wink:

Thank you.

 

[Gabriz]

Hi.
after writing what interests you must use the "disaggrega" command (menu modifies > disaggrega) by selecting the characters to be transformed into lines (command this best known as "explodes" on other cads).
at this point you can create solids, surfaces, pockets at your liking.
Good job!

 

[LordRaiden]

Thank you! Great!