fattori k multipli

[AndreadaGaeta]

Good morning.
I'm a new user. I have some experience with sheet metal modeling
with solidworks. My problem is that by having to give drawings to third parties, these work with developments
different. I would like to know if it is possible with sw to set on the same part two different k factors, or
even have on the table two views explained with different factors k.
thanks to all for the collaboration

 

[MassiVonWeizen]

Have you tried with configurations?

 

[AndreadaGaeta]

Have you tried with configurations?

of course, yes, but without results

 

[MassiVonWeizen]

https://help.solidworks.com/2011/it...n_2011/wn_2011_kfactor_in_configurations.html

 

[AndreadaGaeta]

Okay, thank you.
I think I fixed it.
a last question, is available somewhere a glossary with the names of all solidworks properties.
Thank you again.