finer door quota

[monaco]

Hello, guys.
I'm learning how to use revit and I'm about to finish my first experience but I have a little problem. how do I quota doors and windows in the old way (line axis with fried width height)? I've been wasting a lot of time looking for advice, but I haven't come to terms with it. I'm using revit2010.
Thank you very much

 

[gfrank]

Welcome to the forum
use special door and window labels

 

[monaco]

Thank you. the problem is that I can put the labels but this is nothing but a circled number near the axis that has nothing to do with the measures I want to quote. I should put the classic width-height quota not a number of infix recognition

 

[gfrank]

carica queste (ver. 2010):

 

[MTR]

Good morning gfrank,
I re-exhumed this post looking for directions on labels/quotes for doors and windows and thank you, but being also a neophyte I would like to ask you:
having a door (e.g. building entrance) to three panels, of which only the central opening one, how to associate the width quoted in the label to the width of the opening panel, instead of the hole in the wall?
Are shared parameters the only way? Would you recommend a tutorial to get over it?
Thank you!

 

[Tristan]

the doors and windows have two parameters called "approximate width" and "approximate height" which, if not used for other purposes, could do to your case. set in the family the width and height of the panel with these two parameters and you will not need the use of shared parameters

 

[MTR]

Thank you very much @tristan !
I changed the parameters of the label and in the associated door the approximates to those of the panel and solved!
In the meantime, I will see how to document the shared parameters
if you have any links to suggest a lot of money!