flat wall rectangular by default

[Mr.Rio]

Hello.
I wanted to ask if there is any option to set to make sure that the creation of a flat wall was automatically proposed to me (as a preview) the rectangular wall after selecting the edge of attack. from what read on the help such procedure would seem automatic, however the only way to proceed is that of the sketch.. .
Thank you all!

 

[dema]

If I understood correctly you would like to see how from the attached video, they are that it does not happen in all the pro-e with which I had to deal with are always behaved like this...

 

[Mr.Rio]

If I understood correctly you would like to see how from the attached video, they are that it does not happen in all the pro-e with which I had to deal with are always behaved like this...

Yes, that's what I mean, only that with the proe training edition does not. in the office, with the commercial version, behaves as shown in the footage. the config is the same because I copied the configurations (except start part files). Mah!
Thank you for your interest and for your time :smile: