floor grill

[Sandra_ME30]

Mononoke8 16.12.15 15:39

Hello everyone! I should create a floor-mounted ventilation grille (so by washing it as to put a window on the wall or as an alternative as a continuous facade wall). I tried everything but I couldn't get the result I needed.
Is there somewhere a video or instructions that explain step by step how to insert a grid of this type within the project?
Thank you!
hope that mononoke8 read this thread and register again on the forum :smile:
Unfortunately, not resulting in the registration now, I can not send him a pm.
Sandra

 

[Sandra_ME30]

sadan 17.12.15 08:45

You mean a grill for a good wolf? you have to create a family based on floor... how do you wire it with the creation of families?

 

[Sandra_ME30]

Mononoke8 17.12.15 14:50

originally written by sadan view message
You mean a grill for a good wolf? you have to create a family based on floor... how do you wire it with the creation of families?

then a grid that pits the loft.
I have already tried to create a floor-based family by placing the grid above and inserting an opening from the corresponding command (so not a vault)
The problem is that it cannot associate these three elements to me so as to make them changeable according to the measures I need.
I definitely jump or I'm wrong a few steps, so I've looked everywhere for a clear guide to insert them with little results.

 

[Sandra_ME30]

sadan 17.12.15 17:39

How should it be done? Do you have any reference images?