function shaft (solidworks style insert bar)

[Lorenz578]

Good morning to all, it's my first post after the presentation.
I press that I did a research before posting my question, also using advanced research, but I found nothing about it.
the question is simple and is practically summarized in the title of the post itself.
exists the possibility as in sw to use a Insert bar to provisionally restore a previous state?
for those who used sw I believe understand the importance of this function, which I do not find present in inventor.
thanks to those who will help me.
Lorenzo

 

[Andrea Scarnecchia]

good morning, if I didn't understand the function you need in inventor is managed by the "end of the part" at the bottom of the browser (the one with the red x).
If he drags it up, all that remains below will be suppressed as if it had never been created.

 

[Lorenz578]

Good morning gorea, thank you very much for the answer.
It wasn't even too difficult, I could have gotten there
Thanks again, very kind