holes in the level together

[nunzio1981]

Good evening, this morning I happened to have to drill two parts with a hole passing, then insert a hole at the level together, but I did not succeed; this because the coupling interface was equal and I wanted to save time rather than make single holes. Is there a solution or an equivalent way to proceed?
Thank you.

 

[ceschi1959]

in nx there are no features together. the associative and via-going holes are made with other techniques (wave geometry linker)

Hi.

 

[axa]

hole series?

 

[ceschi1959]

hole series?

hi axa, i never used them, interesting.

 

[Utente NX]

The 'hole series' are axieme processes that transfer holes to the individual parts. very risky if you insert many holes and machining in the individual parts, circular references can be easily born.
If you have to make holes in the environment together, where the holes reside only in the axieme, then use the promote body and the hole function.