hollow hole for screw mx

[mar.dan]

Hi, I continue with my tutorials but I arrived at a point that I can't fix.
if I have to make a hole d5,2 passer-by for a screw m5, how do I do?
I use the "creation wizard holes" function but it only makes me do threaded holes. if I want a passer by screw m5, but not threaded?

Usually in a hole where a screw must pass I have always made a hole of the 2/10 greater diamentro.

how do you do it?

 

[xxfast]

to me do it, you have to select devading and then the hole to perform.in your case m5, because it is a screw hole from 5.

View attachment 23213

 

[mar.dan]

but wanting to place 4 holes rigged for screw m5 (so not threaded) you how would you do?

 

[andle11]

When you need to fix the positions, you create a diameter construction circle you want, and then you'll piss 3 centers on 3 of the four radial points that sw proposes you as a snap.

 

[R.Sergio]

I would do one and use the circular repeat function

 

[SolidUser]

the wizard holes, if inserted more than one, is already a repetition.
performing a circular repetition may be recurring, but it could be the only solution in case the number and pitch of the holes should vary in different configurations.
therefore both the solution of andle11 and r.sergio are valid, depends on the intent of the project.