horsepower

[alegno]

Hello, everyone!

I am here to ask you a little help: I'm modeling a corkscrew (for an examination of the aun) only that I can't understand how to make the spiral....or better I used the "elica and spiral" function and then "extrusion sweep" just that I get something a little ugly...:frown:
Any suggestions?

thanks 1000000000 in advance! !

alessandro

 

[MassiVonWeizen]

How bad? like a confandine with ancestors on the right? like a shining grin? Like a two on the page the week before school?
I'm a virgin. A towel... an oleogram.. .

give us a little help thanks a thousand thousand

 

[alegno]

Put a three on the page from... :
Um, just... the picture. . :

 

[enri]

will not be an optimal solution, but take a look at 3d corkscrew, sketchup format, so looking, or "taking them back" in solid, since they are mesh, you can distract yourself. in these cases we have to understand geometry well.

 

[alegno]

ok thanks in the meantime for the straight!!!

 

[MassiVonWeizen]

It's just... bhé the beauty lies in the eye of those who look(cit.)

try to take a look at this discussion, it might be helpfulhttp://www.cad3d.it/forum1/showthread.php?2175-recuperato-costruzione-3d&highlight=cocleado a search also with tags, sweeps; the results that come out are several and now I have no patience to spulciate myself to see what could be inherent in the case.

You also need to change the section of the propeller (always that this is not a "just for" test, with round section holes the cap but more for pressure than for screwing and then to be able to drink your good pinot you dda pull.. .

 

[alegno]

eheh...I will gladly draw to celebrate once finished... thanks also for this company now I read everything! !