how to deform a rubber part

[cristiano.francioli]

Good morning to all I have a problem, I have a model of a straight rubber bellows that is produced so to adapt it to my application need to deform it so that it is "curved" someone knows how I could approach me? I tried to use the command "global shaping" but can't properly deform the bellows, with the command "global deformation" I don't have the .dat files to insert, how could I make any ideas? thanks and greetings, Christian

 

[ceschi1959]

ciao,
proof of guard qui http://www.cad3d.it/forum1/threads/22502-modellare-tubo-spiralato?highlight=spiralatowith nx swept command and a little fancy, so you can make a 'cilindrical' bellows; If it were different section, you should do a pattern and then a little fancy. I can't be clearer because I don't have the cad.
Hi.

 

[matfio]

Good morning to all I have a problem, I have a model of a straight rubber bellows that is produced so to adapt it to my application need to deform it so that it is "curved" someone knows how I could approach me? I tried to use the command "global shaping" but can't properly deform the bellows, with the command "global deformation" I don't have the .dat files to insert, how could I make any ideas? thanks and greetings, Christian

"correct manner" in what sense? tolerance or just off-measure? What version do you use?

 

[flaviobrio88]

What of the January?http://www.omnicad.com/tutorial/omnifreetransformer-tire.mp4