how to parameterize one apart with red lightning

[cartello]

how can I parameterize a part with red lightning

 

[gianni55]

part design menu
view view
Toolbar
partdesign features recognition

in the bar there are commands to recover parameterization, but they are commands that have limits... you should do it again

 

[falonef]

part design menu
view view
Toolbar
partdesign features recognition

in the bar there are commands to recover parameterization, but they are commands that have limits... you should do it again

part design menu
view view
Toolbar
partdesign features recognition

in the bar there are commands to recover parameterization, but they are commands that have limits... you should do it again

Hi.

Are you sure this works?

Do you have experience?

 

[gianni55]

Hi.

Are you sure this works?

Do you have experience?

Hi.
little direct experience, I rely on the memory of when in the company during the courses it made some attempt to recover of the solids shotguns obtained from step... if by e.g. the command was able to recognize a connection radius extracted the features and with double click you could change the value but only a small inaccuracy and failed. but it's been a century.

Why?

 

[falonef]

pure curiosity.

But it takes an additional license.
with the basic license I do not believe that you are enabled to recognize the various features

 

[gianni55]

pure curiosity.

But it takes an additional license.
with the basic license I do not believe that you are enabled to recognize the various features

I think so, in the company everyone had hd2 and then there were floaters for the step etc. to use in need.

 

[falonef]

I do not know what is included in the hd2