import file dwg problem

[zetadierre]

Good evening,

there are definitely problems with importing a file: from 14 mega dwg after importing 146000 elements (in autocad you see 141000) that lasts two or three bibles read on the contrary, saving the file in wvx you pass to 142 mb.

Now I look at him... But there must be things I have to be careful about?

imported design with only 2d elements and units in cm...

 

[lory.b]

that increases the weight is inevitable, speak different languages.
if it increases so much there could be retinals, which have their weight and also a good amount of lines. you have to do a cleaning job to make it manageable.
I do.

 

[zetadierre]

that increases the weight is inevitable, speak different languages.
if it increases so much there could be retinals, which have their weight and also a good amount of lines. you have to do a cleaning job to make it manageable.
I do.

a weight gain is an account, but from 14 to 144 mega the weight is decuplicated. entities are all lines or polylines. . and the problem is that this file must be bounced from one computer to another over the next few months, I'm doing a thesis and working with self-taught engineers.

 

[pla]

Are you using 2009 or 2010? with the second weight you should reduce a lot, since it better manages the conversion of blocks.

 

[zetadierre]

Are you using 2009 or 2010? with the second weight you should reduce a lot, since it better manages the conversion of blocks.

2009, 2010 edu disinstallata