piersilvio
Guest
good morning to all, I have the following problem: I modeled a simple beam with solid65 in workbench (v.13) and I have assigned the characteristics of concrete material.
I need to display the slot training condition. is it possible to do it in workbench? and in case I have to proceed?
Moreover if the same model is published in apdl (exporting it from wb) I have two elements that I have not defined, i.e. surf 154 and solid 185. but my mesh also in apdl should be in only65. how can I avoid this additional problem in apdl?
thanks to all
I need to display the slot training condition. is it possible to do it in workbench? and in case I have to proceed?
Moreover if the same model is published in apdl (exporting it from wb) I have two elements that I have not defined, i.e. surf 154 and solid 185. but my mesh also in apdl should be in only65. how can I avoid this additional problem in apdl?
thanks to all