inch and mm measuring unit

[snake779]

good morning to all, as from title I would need to make a layout where I have both the size in mm but also in inches. I already know the way to pass the entire document from mm to inches, but I would like to have the condition where I can keep them all and 2. I give an example: I have the quota 100mm, in parentheses perhaps, or next, I would like to write to me 3.93". If this was not possible, I could evaluate to hold the sheet 1 listed in mm and make a copy of the sheet, creating sheet 2 and quota it in in inches, but I couldn't find a way to change the units of measurement only to the desired sheet.

I hope someone can help me. . . ! !

thanks in advance

 

[MassiVonWeizen]

http://help.solidworks.com/2018/italian/solidworks/sldworks/hidd_options_dims_new_dim.htm

 

[snake779]

http://help.solidworks.com/2018/italian/solidworks/sldworks/hidd_options_dims_new_dim.htm

double share!!! Thank you.