increase precision angular bond in assemblies

[Luca Redaelli]

Good morning at the forum,
This is my first post.
I have this problem:

I have to bind a part in an assy with an angle bond of 0.019 degrees compared to another but known that the maximum definition of the bond is 0.1

Is there any setage that allows me to descend to the desired value?

thanks to all

♪

 

[tartufon80]

Bye!

test with this variable: minimum_angle_dimension

 

[Luca Redaelli]

unfortunately remains 0.1 again. .

Thanks anyway.

 

[nino67]

strange.

I with 2 m180 I can easily.

What version are you using?

greetings

 

[DANI-3D]

Bye-bye.

have you tried to dismantle > accuracy? test with relative or absolute and change the value.
I have a set with absolute accuracy 0.03 and it works

 

[Luca Redaelli]

Hi.
I am using the creo version 2 m150, where do I find the definition of precision in this version? ?

Thank you.

Have a good day.

 

[tartufon80]

file -> prepares -> properties model

I'm sorry if I tell you, but by someone who's been using ptc software for 10 years, I'd expect a little more initiative! :mixed:

 

[Luca Redaelli]

thanks for the answers. .

I eventually found out it was a step object developed with imported surfaces, which gave me that problem.

Hi.

 

[maxopus]

and if it were a set of only display?
because there is also that, you enter the value with 2 decimals and he shows you only 1.
try to make a measurement of the angle obtained with the analysis tool.