increased accuracy of the value of the angle

[Sandra_ME30]

The carpet 12:25

Hello.
I am new to the forum and I take advantage of it to greet everyone.
My first question is:
I noticed that in the properties of a line is also visible the angle of the same, but as whole number. I would like to know if there is a way to increase the accuracy of the angle (so that it is displayed up to a certain decimal number and not only in the whole part)

Thank you.
I hope karotto reads and registers again on the forum.
now you can not send him a pm
Sandra

 

[Sandra_ME30]

sadan 18.12.15 12:40

Have you tried with the unit command?

 

[Sandra_ME30]

plannerroad 18.12.15 12:41

unit command and change the value of the accuracy of the corner values.

 

[Sandra_ME30]

The carpet 18.12.15 17:31

Thank you. !