inserting repetitive parts

[RS4]

Does the Commission intend to take the necessary steps to ensure that the Commission is able to take the necessary steps to ensure that the Commission is able to take the necessary steps to ensure that the Commission is able to take the necessary steps? ?

Are we still?? we're in vacation.

 

[cacciatorino]

Does the Commission intend to take the necessary steps to ensure that the Commission is able to take the necessary steps to ensure that the Commission is able to take the necessary steps to ensure that the Commission is able to take the necessary steps? ?

Are we still?? we're in vacation.

Here I am, it actually seems that discussions are going to be exhausted.

relative to your last video, perhaps I was not clear in exposing the topic, which was to see how cads speed up inserting similar parts after the first. I saw that instead in your video every time you have to repeat the top position, going to select the mating surfaces also on the part to add, as well as on the "frame", as it is normal.
if you look at the first video (the one made with if), you will see that the screws after the first do not require the user to select the stem and the subhead during the definition of the constraints: just select the hole and the surface of the bar on the destination part.

 

[ceschi1959]

I think I miss nx, here's my contribution:

in nx it is possible to store the mating constraints in the part by acting from the axieme.
[youtube]qkn47-oxyvi[/youtube]

 

[cacciatorino]

I think I miss nx, here's my contribution:

in nx it is possible to store the mating constraints in the part by acting from the axieme.

See, it works the same way that in itself. :smile: