CADAUNO
Guest
Good morning, everyone.
I modeled a set consisting of single parts and master parts with family. then I created a family parts of which I made some children. I then entered these children, to groups of two, in the views of a 2d multifog table mass which I completed of quotas and what else necessary. Then I saved everything. all this locally, without team center. that in each view (2 for each sheet) one of the two children is put in "not visible" status. at this point every regeneration of the children in the family of the assieme causes me an alteration of the graphics of the views, with modification of the size of the contour, partial reappearance of the components in "non visible" state and repositioning of the views in the sheet. Is there anyone who knows what a similar problem can depend on?
Thank you for your attention and for your help.
♪
I modeled a set consisting of single parts and master parts with family. then I created a family parts of which I made some children. I then entered these children, to groups of two, in the views of a 2d multifog table mass which I completed of quotas and what else necessary. Then I saved everything. all this locally, without team center. that in each view (2 for each sheet) one of the two children is put in "not visible" status. at this point every regeneration of the children in the family of the assieme causes me an alteration of the graphics of the views, with modification of the size of the contour, partial reappearance of the components in "non visible" state and repositioning of the views in the sheet. Is there anyone who knows what a similar problem can depend on?
Thank you for your attention and for your help.
♪