interference in movement

[BIXIO]

I press that I come from inventor, where this command was very simple.

we have a door, which opens turning on its pin, is it possible to simulate the movement of the door opening by verifying the interferences?

example in inventor I put a bond for the opening angle, then I told him to animate said bond, popping up the search for interference.

as soon as she found a interference she was blocking and highlighting the same.


Is it possible to do the same thing with sw?

 

[Oldwarper]

there is the hinge coupling, in the set of mechanical couplings, which allows you to impose an opening angle for rotation.

to check interferences just move component and select identifies collisions. moving/breaking the piece the collisions are identifying highlighting collision point and pieces involved and if you also want the "bottom... "

 

[michele81]

if you have set the correct couplings, to simulate interferences you can simply use the comaendo "component position" indicating between the "coult identification" options; this allows you to move the part normally along the degrees of freedom you left free, but as required it blocks when there are interferences.
I hope I helped you.
greetings
Michael

ops have arrived betrayal!

 

[BIXIO]

thanks for your help found everything. :finger:

I feel like a goat.