Domyco
Guest
Good morning to all.:finger:
I press that we are talking about intralink 3.4 and wf3.0
I have a little problem:
I can not export to disk the full or partial content of a ws.
in particular if I check out a .doc or a .dxf export it but any other file that concerns pro-e like drw or prt or asm does not.
I would like to have done the operation of interoperability to make the two software recognize, otherwise pro-e did not leave and vice versa.
Can anyone help me?
Thanks 1000:frown::frown::frown:
I press that we are talking about intralink 3.4 and wf3.0
I have a little problem:
I can not export to disk the full or partial content of a ws.
in particular if I check out a .doc or a .dxf export it but any other file that concerns pro-e like drw or prt or asm does not.
I would like to have done the operation of interoperability to make the two software recognize, otherwise pro-e did not leave and vice versa.
Can anyone help me?
Thanks 1000:frown::frown::frown: