[inventor beginner] remove solid from another solid

[MBT]

is still very aleatory and opinable. . .

 

[Ilario]

I say mine:
I use practically always the hole, even in case of milling, it is enough in the drilling window to indicate hole with flat termination, always for the next quotation speech and also for "visibility" processing in the browser processing. the negative cylindrical extrusion use only and only if I have "fretta" and in case it is necessary to have a quota or reference in sketch from the end of the hole tangent... I repeat, only if I am in a hurry because otherwise I press the reference of the circle and pitch a hole in the middle of the circle and I make a hole however with parameterized diameter at the altitude of the circle in the sketch. . .

 

[Daniele_69]

everything is opinable. I said how I behave: if I have to make a hole use the hole command and in other cases I use the extrusion of a circle. said this you can also make the revolution of a rectangle in size mode and get the same result. then everyone is free to use the processing they prefer and get the result they believe.

 

[stefanobruno]

I didn't know if you were right or not, I was basically what I meant for this kind of experience.

before you said.
I'd never let myself contradict you, especially when you're right.

Bye.

 

[Ilario]

before you said.
I'd never let myself contradict you, especially when you're right.

Bye.

If I'm wrong you have to contradict me though:

 

[massimo.l]

hole or extrusion.... every scarrafone.....
in phase of modification from hole to hole laminated or flushed or threaded, the change would become more direct.:finger: