falcorsv
Guest
good Sunday to all, and I apologize if the topic has already been dealt with but I have not been able to find feedback, so if someone has already faced it can direct me to the discussion? Thank you in advance.
the problem is the following.
Today after some time I created a welded set with inventor to do some exercise. when I went to make the table and I realized that the view was blocked (the first but also all the derivatives of the first), i.e. it was not possible to move it up or down to the right and at least left of the sheet. I remember that the last time I used it was a wonder but now I can't figure out where the problem is, I looked in the forum but nothing.
I thank in advance all those who will read the subject, and all those who will be able to give me advice to solve the problem.
the problem is the following.
Today after some time I created a welded set with inventor to do some exercise. when I went to make the table and I realized that the view was blocked (the first but also all the derivatives of the first), i.e. it was not possible to move it up or down to the right and at least left of the sheet. I remember that the last time I used it was a wonder but now I can't figure out where the problem is, I looked in the forum but nothing.
I thank in advance all those who will read the subject, and all those who will be able to give me advice to solve the problem.