Inventor to create sculptural models??

[bagarospo81]

Hello, I would have a basic experience on cad 3d in particular on inventor and I was proposed to make a prototype for a very particular glass as form and function.
I wanted to know if inventor could somehow be useful to the purpose or should use cad dedicated to surfaces and sculptural modeling, of which however I completely ignore names and functioning.
What about you? Is the company on inventor feasible or would it result in an exhaustion without results? ?
Thank you.

 

[gil]

I answer you in the other topichttp://www.cad3d.it/forum1/threads/48313-consiglio-per-cad-scultoreoI suggest administrators to delete this discussion to avoid the discussion being spread over multiple threads

 

[bagarospo81]

Yes look you are right is just that the section of the other topic seemed a little deserted and then I actually started using inventor for the company.