ipart editing in assembly

[fiorot.daniele]

after searching everywhere including driving to you... can you change a value of an ipart directly together?
pùo seem trivial but if I have to change a "configuration" I always have to open the part in the table change and close after in conjunction...:frown:
I ask you this question because in solidworks this problem did not exist as you directly altered the value together.
I hope someone had my own problem
thanks in advance

 

[batleo]

hi from the assieme selections the part if it is in the center contained and I choose modification definitions, or you can use ilogic

 

[fiorot.daniele]

Thank you for the answer.
As for the content center I have already uploaded components what is not clear to me is ilogic but I think I better take a ride in the guide as I have never used it. . .
If you can give me two straights thanks:redface:

 

[bypass58]

in combination right-click on table (in the browser), activate the tab tab, at the top you will find a new "new" line, change the parameters and save the new line, automatically change the configuration and create a new configuration. this is also valid during the insertion.