nicolalocin
Guest
Hello everyone,
I have a plate that has irregular thickness (see attachment).
How can I make the contouring of such an irregular profile?
the crude is increased by about 20mm and at the maximum point of the plate.
I tried to use the processing command for isoparametrics that recognizes me this profile but it suddenly enters me into the rough and rubs the contour leaving all the crude behind.I can't do it from the outside
p.s the photo shows a view and the upper floor; is not rotated therefore the lower thickness is increased and higher.
Thank you very much
I have a plate that has irregular thickness (see attachment).
How can I make the contouring of such an irregular profile?
the crude is increased by about 20mm and at the maximum point of the plate.
I tried to use the processing command for isoparametrics that recognizes me this profile but it suddenly enters me into the rough and rubs the contour leaving all the crude behind.I can't do it from the outside
p.s the photo shows a view and the upper floor; is not rotated therefore the lower thickness is increased and higher.
Thank you very much