language

[Pierobia]

Good morning.

I would need a suggestion on how to draw this tab: (This is the lock tab for a panel lock).
especially how to make the final rounded part.
in practice the upper part, with the hole, is flat, the central angled part continues from the top and from the plane goes to round and finally the last piece is completely rounded.
Excuse me, I hope I have written in an understandable way.
Thanks to who would help me.

 

[doriano]

I'm sorry, but to draw you want to put on the table? or create a 3d model?
Clear.
Dominican

 

[Pierobia]

I'm sorry, but to draw you want to put on the table? or create a 3d model?
Clear.
Dominican

Sorry, I meant creating a 3d model.
Hi.

 

[doriano]

Well, then you do this: the initial chord you do after
1st- you create in a sketch the various sections in the exact positions where the surfaces begin and end (flats, rounds)
2nd- create the extrusion profile ( create it by switching it to the centers of the various sections)
3°- if you use the surfaces, go to "multisection surfaces" (selections the various sections, profile selections) and sweep
4th-if you use the "part" you do it with "functional solid
I hope I've been helpful

 

[Pierobia]

Well, then you do this: the initial chord you do after
1st- you create in a sketch the various sections in the exact positions where the surfaces begin and end (flats, rounds)
2nd- create the extrusion profile ( create it by switching it to the centers of the various sections)
3°- if you use the surfaces, go to "multisection surfaces" (selections the various sections, profile selections) and sweep
4th-if you use the "part" you do it with "functional solid
I hope I've been helpful

Thank you. I'll try it right away.