liaison between parties

[enzop805]

Hello.

I would have a problem, provided that I am a proe user and am accustomed to using other methodologies.
I would like to know how I can import geometries from other parts (in proe copygeometry, in nx linkedbody).
I'm explaining I'm drawing a motor shaft and there are two types of cranks that have in common some sizes call it a.
Is there a method that allows me to change to a single part that changes accordingly on all linked parts?

Thank you.

 

[robcrac]

use copy -> as result with link. in this way what you change on the source file is reported in the target file

 

[enzop805]

perfect thanks for the advice.

I only have a small problem in placing the piece. I tried with the translation command but this message comes out

"Instead of turning an import directly, it is advisable to apply the context command add position to the solid (I know where it is). then apply the required gsd transformation to the position group axle system" use this method si no"

what is the best procedure and how the caia council follows (I tried but nn managed).

thanks in advance

 

[robcrac]

I never happened this situation and not having v5 below but I can't think back. rereading the initial message, I would say that the best thing, after copying the parts in common between part and part, the positioning of the same should be done in context together using the constraints

 

[enzop805]

Okay, thank you.

I have the methodologies on proes that is a little different from catia