linear repetition command sketch

[michele81]

Good morning
in the construction of the layout of a set I am trying to account a linear repetition within a sketch.
during the creation of the repetition imposed both "add spacing quota" and "counting instances" so as to fully control the sketch.
every time however that I change the number of instances of repetition, the share of spacing is detached from the sketch and becomes useless.
Is there a way to control the sketch repetition?

p.s. I cannot use the linear repetition of extrusions/corps because I am preparing the layout for a revolution extrusion.

greetings to all and a thank you to those who have some advice.

 

[Mike1967]

Good morning
in the construction of the layout of a set I am trying to account a linear repetition within a sketch.
during the creation of the repetition imposed both "add spacing quota" and "counting instances" so as to fully control the sketch.
every time however that I change the number of instances of repetition, the share of spacing is detached from the sketch and becomes useless.
Is there a way to control the sketch repetition?

p.s. I cannot use the linear repetition of extrusions/corps because I am preparing the layout for a revolution extrusion.

greetings to all and a thank you to those who have some advice.

...and complain?
up to some version there was not even count of instances. . .

 

[SolidUser]

Good morning
in the construction of the layout of a set I am trying to account a linear repetition within a sketch.
during the creation of the repetition imposed both "add spacing quota" and "counting instances" so as to fully control the sketch.
every time however that I change the number of instances of repetition, the share of spacing is detached from the sketch and becomes useless.
Is there a way to control the sketch repetition?

p.s. I cannot use the linear repetition of extrusions/corps because I am preparing the layout for a revolution extrusion.

greetings to all and a thank you to those who have some advice.

I suggest you report it to your dealer, this is definitely a kiss.

 

[SolidUser]

I reported it myself and they told me that maybe with sw2011 sp3 should be solved.
I hope it wasn't just the two of us who reported it.. . otherwise perhaps it becomes a we will see.

 

[SolidUser]

The var gave me the spr 589883 inherent to the problem of sketch repetition.