loft between different sections

[Loutenr1]

Hello everyone.. Maybe I'm reassembling, but I can't make the loft between two sections that are of different thickness. practically the piece begins with a thickness and ends thinner:wink:.
I call the neuro? :frown:

 

[Simo91]

I tried to create it anky, actually you can not do it.
The only way I can think of creating that solid is to make loft extrusion on the outer dimensions of the two profiles, and then perform a loft cut with the internal profiles.
If you have to put it in a set it will take a century to open but you should get a decent rusting.

 

[controllofiamma]

I think you can't do that profile with loft, I'd do a full job, and then make an extruded cut with deformed

 

[marcof]

I can't make the loft between two sections that are different in thickness. practically the piece begins with a thickness and ends thinner:wink:.

with the loft you can't do it. make an external loft then share the sketches and make it an inside excavation

 

[Loutenr1]

thanks to all for the answers... I had the doubt that I had gone mad:biggrin: