mastercam x 5

[chip_20]

hello to all, domandina: the "machine simution" is included in mastercam x 5?
the milling machine simulation with a lot of machine working the piece.

chip_20

 

[xdxxdy]

the simulation machine is included but from what I know you can not simulate the machine code but only the trajectories you see also in the backplot, if you need to simulate changes ut, accelerations, pistons etc then you have to look elsewhere, see veracut and similar, indeed veracut simulates everything but you can not see the machine at speed 1:1 because it is performance oriented and the timers that would slow it there are, however the cycle time

 

[mirkosg]

use eureka virtual machining, it is easy to use and perfectly digests any iso