material for thesis

[ford]

Hello everyone, I am about to write thesis, three-year degree, on the process of bending steel fittings, in this regard you know some site where to find material? I wandered on google but I didn't find much...
Thank you all.

 

[meccanicamg]

Hello everyone, I am about to write thesis, three-year degree, on the process of bending steel fittings, in this regard you know some site where to find material? I wandered on google but I didn't find much...
Thank you all.

hello ford, but the thesis that you're preparing for your choice? by chance? Did you do your internship at a company? Does anyone follow you? Your speaker says? I think we should have a few half ideas at least on the process and contact some company, available, to give you material and to make you a free collaboration.

I am thinking that curved steel fittings are of various kinds, from those that are used to weld gas distribution pipes, to those adopted for fumes discharges (without welds....even if there are not many) and of melt there will be other types but I think you refer to the first type.

 

[PierArg]

hello ford, but the thesis that you're preparing for your choice? by chance? Did you do your internship at a company? Does anyone follow you? Your speaker says? I think we should have a few half ideas at least on the process and contact some company, available, to give you material and to make you a free collaboration.

I am thinking that curved steel fittings are of various kinds, from those that are used to weld gas distribution pipes, to those adopted for fumes discharges (without welds....even if there are not many) and of melt there will be other types but I think you refer to the first type.

quotone, if you want to do something "serious" you have to try to involve some company that is particularly available.

Of course I know that it is a difficult undertaking (even I studied in calabria at unicol) because there are no companies.:frown:

 

[ford]

I did an experience in the company in fact in the afternoon I go there,cmq I know that I am the first one who took care of this, we hope they have enough material...

 

[numero1]

but do you mean catalogues or something + sophisticated? that is how they are physically produced.
for the first should be no problem.

for mecca and fordhttp://www.snamretegas.it/it/lavora_con_noi/pdf/gasd_c.02.01.00.pdfDid you mean something like this?
Hi.

 

[meccanicamg]

for mecca e fordhttp://www.snamretegas.it/it/lavora_con_noi/pdf/gasd_c.02.01.00.pdfDid you mean something like this?
Hi.

Yes, yes.

 

[ford]

I was afternoon in the company and I found material on the realization of the fittings by turning...if I found now material inherent to the bending process(images, drawings, various problems) would be good because if not otherwise I have to do it from the beginning...