Teopado89
Guest
Good evening,
a colleague has the following problem and I would like to help him:
in its molds for the production of glass sometimes happens that the matrices are cracked, and cannot understand the cause.
I was thinking about making ansys verification (it has been almost two years that I do not use it), but this is a condition of thermal and mechanical tensions.
how would you deal with the problem?
I have seen that there is also the ansys polyflow software that also treats glass, but I think it is more "concentrated" on the piece (to make a comparison with plastic, can I say that it is like moldflow?), while to me in this case it is interested to verify the mold.
thanks in advance
a colleague has the following problem and I would like to help him:
in its molds for the production of glass sometimes happens that the matrices are cracked, and cannot understand the cause.
I was thinking about making ansys verification (it has been almost two years that I do not use it), but this is a condition of thermal and mechanical tensions.
how would you deal with the problem?
I have seen that there is also the ansys polyflow software that also treats glass, but I think it is more "concentrated" on the piece (to make a comparison with plastic, can I say that it is like moldflow?), while to me in this case it is interested to verify the mold.
thanks in advance