Dmaz
Guest
Hello everyone, I have a number of surfaces imported in rhinestone, some as average surface of the reference piece, others as external surface (so I have to specify an offset in the program).
My doubt is as follows:
when I have to make a mesh of a surface with offset. I must first specify the offset (attributes/face/offset) and then meshare with automeshing, or first meshare the surface I have (so external) and then make the offset as specified before?
because in the second case you have a nice regular mesh at the external surface in the first mesh is displayed at the right point but it is all disconnected. .
Thank you!
dmaz
My doubt is as follows:
when I have to make a mesh of a surface with offset. I must first specify the offset (attributes/face/offset) and then meshare with automeshing, or first meshare the surface I have (so external) and then make the offset as specified before?
because in the second case you have a nice regular mesh at the external surface in the first mesh is displayed at the right point but it is all disconnected. .
Thank you!
dmaz