Messa in tavola 2d, tempi Lunghiisisim.

[spilladabalia]

Good morning, everyone.
I'm trying to get a prospect from a 3d model made with rhinoceros...it's been processing since 15.00 yesterday, night included and I'm writing you at 8.45...you know something's wrong!
What could be?
Thank you very much...:smile:

 

[mariuss.r]

Good morning, everyone.
I'm trying to get a prospect from a 3d model made with rhinoceros...it's been processing since 15.00 yesterday, night included and I'm writing you at 8.45...you know something's wrong!
What could be?
Thank you very much...:smile:

I would say that the information you provide us is a little bit short to give you an answer:

Is that a heavy file?
have you tried to eliminate all the geometric entities that have nothing to do with the table?
How much ram do you have on your pc... what kind of pc do you have? (to understand the processing power)

cmq I would say that something has been planned, because even with a 486 after 16 hours should have ended:

 

[enri]

I think you have a geometry that doesn't work, it happened to me, it gave me insufficient ram and it didn't go any further. As for me it was a very wide double curvature surface with a solid offset of one cm, he did not like.. remove no problem. do some tests by eliminating the geometries that you think are more problematic.

 

[gio_alias]

Try to push the camera away if you're in perspective... If you have an accentuated wide angle and you get too close to the object, you go out with a vector, you don't need to be close. . .