Modeling 3d table aratro

[matte22]

good evening to all and I apologize already in advance for the little frequency of attending the forum, I should realize the model 3d of a table of an aratro but I do not know how to do... Somebody give me a tip?

thanks in advance

 

[TECNOMODEL]

through extrusions, revolutions, sweep etc....
all from sketches, of course.

 

[matte22]

through extrusions, revolutions, sweep etc....
all from sketches, of course.

thanks to the answer, but I would also deny to create a final development for cutting, which with extrusion and revolution I can not do.

 

[TECNOMODEL]

Do you realize you put the question in a way that it is impossible to give you an answer?

 

[matte22]

Do you realize you put the question in a way that it is impossible to give you an answer?

I realize, but the design is bound to a future realization, so I also need a file with development and then send it to the laserista for cutting.
the fold happens by means of appropriate molds, the speech of the sweep etc. can be good for a presentation speech.
Thank you

 

[Geppetto82]

if I have understood you have to create a 3d model starting from a 2d design?

 

[matte22]

if I have understood you have to create a 3d model starting from a 2d design?

hi, I have to make two distinct sizes for two different araters, for one I have the 2d file and I have no problem since I use the fold function (correct me if wrong function or you know others), the other I have to create it from scratch or better I have the measurements on a sheet of paper.
for what I have to do from scratch I need at the end of drawing a 2d file with development to send to laserista.

thanks in advance:finger:

 

[Geppetto82]

Hello, there is not only the Hihihi fold function! Look at some tutorials on the sheet!
for the other design do the 3d to follow realize the putting into the table on the false line of the 1'

 

[TECNOMODEL]

I press that I do not know the sheet metal environment, would it no longer be correct to model the 3d with the various folds/curvatures and then "to stretch" the model and then to put on the table?

 

[matte22]

I press that I do not know the sheet metal environment, would it no longer be correct to model the 3d with the various folds/curvatures and then "to stretch" the model and then to put on the table?

Sorry I'm late in the answer... .
Thanks for the answers now I try.