multistep analysis and load

[nicnoc]

Good evening and wishes to all.. .
I usually use ansys workbench, however lately for work issues I was asked to switch to classic ansys.
the problem is that I have to carry out an analysis on 3 steps that includes:
-impose force at the end of a bar
-step 2:remove force (evaluate plastic deformation)
-step 3: Apply a new and different force

on workbench is not a problem you prepare in 30 seconds. however in classic ansys I can not really; I can't even figure out how to define multiple load steps. . .

thanks in advance for the answer

 

[Lucaallegrini]

hi, sorry if I interfere, I would have the same problem, but on ansys workbench; i.e. I can't set more loads in series, i.e. at a certain moment, I put a load, I take it and then I applaud another one.
Can anyone help me?