mystery bond part/axieme

[Alberto1961]

good morning group, this my problem; I have a set formed also by subsets. I put in a new part, and as soon as I put a bond, the part stops me by preventing me from putting other necessary constraints. I noticed that after a tot of inserted parts, this happens to me. solutions/comments? Thank you.

 

[graziano-g]

Hello, an image? version of inv?

 

[Alberto1961]

the version of inventor is the last, 2023.
I can't place the tie rods diagonally in my hole. with any constraint I put first, the tie remains blocked.....

 

[Alberto1961]

So...news... I managed, maybe because the red tie was very far from the wing of the putrella. Anyway thank you very much

 

[Catafratto]

the version of inventor is the last, 2023.
I can't place the tie rods diagonally in my hole. with any constraint I put first, the tie remains blocked.....

sometimes happens due to problems of constraints at any other point of the assemblies: if there are errors (but this is reported) or sub-wins (e.g. many perno-hole constraints that leave the rotation free) or other cases that the bond resolution system fails to calculate correctly. if the axieme is small some sub-invictions are "absorbed" impattano but the more the number of elements grows worse is.
a quick test of 9 is to select all the elements of the axieme, fix them (possibly by suppressing constraints) and see what happens to the rebel bond.

 

[Alberto1961]

in fact it is as you say rightly, thank you