mrwolverine
Guest
Bye to all,
I have a problem in creating a network with the creo 3 cabling module.
in brief:
I have "designed" the components of the wiring, assigned the entry ports (round).
problem:
when I create the network, selecting the entry ports the system does not recognize them as such and creates a location of type "vertex" and not connector, therefore creates a segment "point-point" without tangency with the entry ports.
Does anyone know what the parameter to change is?
Thank you.
a.
I have a problem in creating a network with the creo 3 cabling module.
in brief:
I have "designed" the components of the wiring, assigned the entry ports (round).
problem:
when I create the network, selecting the entry ports the system does not recognize them as such and creates a location of type "vertex" and not connector, therefore creates a segment "point-point" without tangency with the entry ports.
Does anyone know what the parameter to change is?
Thank you.
a.