new model name, problems in table setting

[giuseppe_fidelibus]

Bye to all,

After making a table of a .prt, I had to rename model 3d, causing, of course, error in opening the corresponding table. I renamed the .prt again with the old name and put it on the table reopens quietly as it should. I, however, need to rename the model: How can I do to preserve the relative table? Thank you.

 

[maxopus]

if you do not have a pdm, you must rename the part from the program and never from windows keeping open the assemblies and the connected table that you have to save once renamed the part.

 

[giuseppe_fidelibus]

Thank you! solved!

I had actually renamed through the program as I always do, but at that time I didn't have the corresponding .drw opened at the same time. Thank you!