new nx5 user and i have some questions! ! !

[hassouna80]

Bye to all,
I have worked for many years in design using solid works and now for various reasons I have to use nx, I would like to know, according to you if nx is more powerful than solidworks or is it wrong? ? ?
In addition I have some difficulties on certain functions and I would like to know:

1- I can make a hole or a workmanship on a set but I can't do the repetition of processing because? ?

2-if I make a hole on a set and I want to connect this hole to a hole that was already on a particular as I do (for example create a concentric bond or ....)?? ? ?

3- is there a library of screws and nuts and bearings that can be used ? ec how do I have it? ?

4-Is there a detailed guide of nx? ?

thanks and I expect your answers

 

[IPdesign]

hi hassouna80

First, I invite you to present yourself in the appropriate section in this subforum so that all those who read may have a picture of your figure.

for your questions:

1) it would be necessary to know which procedures adopted.
2) a hole is not done on a set, but always on an existing feature = a partfile.
do not confuse the fact that you work in assembly with the work part active.
3) Yes, there is .. connected to the site ftp of siemens and download it (if you are under mnanutenzione )
4) there is the online cast that helps a lot especially to the first weapons, however it is highly conscious at least a first basic course; this prevents you from using nx with the solidworks approach. nothing more wrong.