normal nx5 surface

[Ghioss]

Good morning.

I imported a mathematical model from another system getting
only surfaces whose normal do not have the same direction. there is the possibility of
uniform them in the same direction (to facilitate the task of creating an offset) by selecting them all at once without checking them one by one?

Thank you.

 

[axa]

Good morning.

I imported a mathematical model from another system getting
only surfaces whose normal do not have the same direction. there is the possibility of
uniform them in the same direction (to facilitate the task of creating an offset) by selecting them all at once without checking them one by one?

Thank you.

You should try "cuciating" them with the sew.

 

[Ghioss]

OK I tried, I didn't solve the problem in one shot because the mathematical model they sent me is not perfect, but I have speeded up my work very much.

Thank you.