nx8 - develop a surface on a floor

[maurot]

Hello everyone,
I have a problem nx8.

Is there a function that allows to develop a surface on a plane?

I'll explain better.
I'm drawing an acoustic guitar to practice.
I designed two surfaces for the "fashes" (so called), i.e. the sides of the guitar.

acousticfasce1.jpg
...... .

acousticfasce2.jpg


Now I should, let's say so, carry out them, develop them on a plane so as to have the form of the material (wood in this case) to "draw" for a subsequent bending.

I also tried to use sheet metal functions but without results. . .

thanks for the attention! !

Mature

 

[Utente NX]

Hello everyone,
I have a problem nx8.

Is there a function that allows to develop a surface on a plane?

I'll explain better.
I'm drawing an acoustic guitar to practice.
I designed two surfaces for the "fashes" (so called), i.e. the sides of the guitar.
Now I should, let's say so, carry out them, develop them on a plane so as to have the form of the material (wood in this case) to "draw" for a subsequent bending.

I also tried to use sheet metal functions but without results. . .

thanks for the attention! !

Mature

1) global shaping
2) metaform
3)one step formability

or use sheet metal because the first three need a special license.
If you couldn't do it with sheet metal, attach the files we look at.

 

[flaviobrio88]

or check boundary length

 

[maurot]

Thank you all!
I finally solved with sheet metal functions, especially "solid piano".

Thanks again for the support!