robys988
Guest
Good morning, I finally found a valid cam program for me(many tutorials on the tube).
need only a clarification on the creation of a tool I put the various measures asked in the tool geometry screen but I do not understand what to put in the parameters, since I did not study mechanics and p only a hobby and. If someone could explain to me the various parameters to what they need I have to use a 6mm 5 cutters on plexyglass but I don't know where to put the z value for each pass, the speed of advancement.
the feed rate I assume is the advance in mm/s the spindle peed I think are the spindle turns the number of flutes I believe the number of cutters for the rest I do not know what the parameters are for....you know how to explain to me you. thanks greetings roberto
need only a clarification on the creation of a tool I put the various measures asked in the tool geometry screen but I do not understand what to put in the parameters, since I did not study mechanics and p only a hobby and. If someone could explain to me the various parameters to what they need I have to use a 6mm 5 cutters on plexyglass but I don't know where to put the z value for each pass, the speed of advancement.
the feed rate I assume is the advance in mm/s the spindle peed I think are the spindle turns the number of flutes I believe the number of cutters for the rest I do not know what the parameters are for....you know how to explain to me you. thanks greetings roberto