pattern design help

[fedele14]

good morning to all, I should draw a sheet with a plot similar to that in photo but with autocad I can not find a command that helps me and simplify in drawing this plot. the design must then be saved in dxf and exported to be made to laser.
would you help me and advise me some commands, how to operate or alternative autocad software to simplify my work?
Thank you very much

 

[MassiVonWeizen]

if you do it with autocad you definitely have to work in 3d, make cuts (of which I do not know the command) and then development (see debate)
or use one of the many three-dimensional cads that cost a bang or you look for between me cad free mentioned in the forum

 

[fedele14]

to me it would be enough also to work in 2 d and to realize the design with that plot

 

[MassiVonWeizen]

and then where the problem is. uses autocad
Draw the side of the side and inside you make the silhouettes of the portraits.
repeat for 4 sides
you calculate how much material it takes to bend, insert it between the 4 shapes of the sides previously made and you got your sheet to send to the laserista